![]() ![]() ![]() Improved UX of remote access from Luban, the touchscreen will only ask for authentication once. Slow down Z bump speed when homing (G28) to get better consistency.įixed a bug that nozzle tip may hit the bed when moving to the next point in auto-leveling if probe sensor is assembled too high.įixed a bug that positions in manual leveling are not saved correctly.įixed a bug that controller may halt down when finishing print.įixed a bug that FANs are not recovered when recovered from Power-Loss.įixed a bug that machine may restart job when recovered from Power-Loss and immidiately trigger Filament runout.įixed a bug that home offset is cleared when resetting settings.Īdded an option for turning on/off anonymous data sharing (which is on by default).Īdded management pages for enclosure add-on.Įnhanced the stability of print data transmission. You can check the About page for the firmware version after the upgrade.This firmware update is only compatible with the Snapmaker 2.0 devices.Fixed a bug where parsing G-code files could cause a crash on the touch screen.Fixed a bug where the machine switches to the wrong coordinate system in 3D printing mode.Fixed a bug where adjusting temperature settings causes the tower temperture to become invalid.Fixed a bug where “Auto-Leveling” is off, the machine will run Fast Calibration before every print. ![]() Added an export log button for exporting log files to USB devices in settings.Added IP address information on the About page.Added the option to switch Fast Calibration on/off in advance settings.Here comes the latest version of the Snapmaker 2.0 firmware. Thank you for your suggestions on how to make the Snapmaker 2.0 better. You can report any bugs or make any suggestions in the discussion thread. We will release the latest Snapmaker 2.0 firmware updates and downloads under this topic. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |